Use case P53 · Human
Electronics hobbyist uses Claude and Fable 5 to adapt a flight tracker to the wrong board and resize its printed case
- Electronics and 3D printing
- Advanced
- Claude, Fable 5
- Source checked · blog post
The short version
What they did
Vijay Sarathy started a small flight-tracker project for his son, but received a different ESP32 board from the one he ordered. He used Claude and Fable 5 to revise the wiring plan and firmware, diagnose a blank display and enlarge the case model for reprinting. He reports getting the tracker running before repurposing the same device as a Claude-usage display. This is his own physical build, not evidence that an AI can safely verify someone else’s soldering remotely.
Result (as claimed)
“After that, the screen lit up and showed me the config screen. Nice!”
“I just had to the reprint the revised case, shoehorn the electronics in, enter my GPS coordinates, and voila - I was tracking planes flying over my home.”
Prompt
I’m adapting a flight-tracker project because I received a different ESP32 board than expected. My actual board is [exact model], my display is [model], and the symptom is [what happens]. Attached are [original wiring plan, firmware, board photos and case model].
1. Compare the original and actual board connections using their documentation, and give me a pin-by-pin table.
2. Propose one display test at a time, with the expected result. Wait for my observation before continuing.
3. Once the display works, help revise the tracker firmware and resize the case using [measured dimensions].Explain changes in plain words. Mark uncertain pin labels instead of guessing. Have me unplug the board before changing wires, and don’t treat a blank screen as proof of one particular fault.
Do it yourself
These steps are my suggested way in, not Vijay’s setup.
What you need
- An ESP32 board and display, plus a USB cable and the board’s exact model name.
- An open-source flight-tracker project to start from, and a free way to flash firmware such as the Arduino IDE.
- A chat or coding assistant: Claude, ChatGPT, Gemini or Claude Code. A 3D printer only if you want a case.
Start simple
- Photograph both sides of your board so the labels are readable.
- Send the photos, the project’s wiring plan and the Prompt above. Ask for a pin-by-pin comparison.
- Wire one part at a time, with the board unplugged.
- Flash a simple test that only lights the display. Then flash the tracker.
- If something fails, ask for one test at a time and report what you see.
Take it further
- Ask for changes to the case model to fit your board, then print a small test piece before the full case.
- Add your location and a few settings to a config screen.
- Reuse the same board for a second display, as Vijay did.
Check your work
- Check each pin against the board maker’s own pinout, not only the AI’s.
- Measure the board before you resize the case.
- Electrical safety: unplug before you change any wire, and check the display’s voltage before you connect it.
Source checked. The link, author, date and quote were confirmed against the source. The result itself has not been reproduced. Prompt adapted for this library, inspired by the case. Business size: Individual. Results are quoted as the source claimed them and never improved. Spot an error or a broken link? Email charlie@cbarmorecpa.com.